Technical data
Measures: 390x113 mm
Weight: 30 g
Material: 0.8 mm PP (Polypropylene)

Stabilizer tabs
The attachment features two tabs that folds in underneath the velcro strap. They provide stability so that the SPEED MULLET holds it's position even under rough conditions. They also make sure that the right angle is achieved, regardless if you have a thin steel frame or a fat carbon frame.

Cable Managment
Thanks to three silicone bumpers and the specific routing of the strap, two channels are formed between the frame and the mudguard. This enable the SPEED MULLET to work flawlessly with downtube mounted cables. If your cables are without cable housing they will run freely in the channels without scratching your frame and with no impact on your shifting. 

EXCEPTION! For safety reasons the SPEED MULLET should not be used in connection with uncovered cables for the rear brake. This is not very common but if your bike has mechanical disc brakes, please make sure your downtube brake cable has housing before using SPEED MULLET.

Mounting position
To give your feet the best protection, make sure to fold the outer edges of the SPEED MULLET at almost 90 degrees so that they are facing forward and place the mudguard as close to the wheel as possible while still maintaining clearance for steering. If you are looking for maximum drivetrain protection, fold the outer edges just slightly and place the SPEED MULLET further down, closer to the chainring. 

Important check
Just for safety, please check for steering clearance and brake function before each ride.